![]() |
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
Network Settings ( My Network Card connects to)=Blankthis thread has 1 replies and has been viewed 283 times
|
![]() |
|
|
Thread Tools | Search this Thread | Rate Thread | Display Modes |
|
#1
|
|||||
|
|||||
|
Network Settings ( My Network Card connects to)=Blank
In trying to change "Private connection" so it would connect to my work VPN,
anyway it appears i messed up my settings for my Wireless Internet connection. On Network Connection (Network Card),Configure Network Adapters. "My Network Card connects to" the Combo box would usually contain Internet,Work if i remember. Now there are no entries. All my Network Adapters are still there. If i Soft Reset then i will receive a Notification about "this Adapter connects to (Internet/Work), i select Internet and i will get internet access. It then seems to lose this choice after a while. This has affected my ActiveSync connection. Using Wireless card and if i check it's IP, Mask etc are all correct. Is there a way without Hard Reset to return to the Default Network Settings. By the Way i did rename the 2 Connections from "My ISP, My Work" could that be a problem |
|
#2
|
|||||||
|
|||||||
|
My network card connects to = BLANK
I have the same probs
Have you found a way around this yet? =RickW |
![]() |
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
|
|